Can someone explain what the second number is under “Power” when I look at the results of my workouts? The first number is obviously my average power, but what is the second number? At first I thought it was the target, but it obviously is NOT target power. What is it? I’ve been looking around for t…

can you upload a screenshot highlighting what you mean? The green/yellow line is your ‘current power’. The number will depend on how your power smoothing is setup. Could be pretty variable.

[Screen Shot 2020-02-01 at 2.18.25 PM] I’m 99% certain the numbers on the left are my average power. I used to think the numbers on the right, the smaller ones, were target power, but they don’e match the designated targets for the workout. I’m still not clear on the diff between the yellow and t…

this is what you see in the interval section after the workout? its the actual power avg (what you did) for the interval vs the targeted power for the interval.

so if you adjusted the intensity to e.g 105%, the green line would be the target for the workout done at 100% (according to yor set FTP value). then the target you seeduring the workout will be 5% higher than what shows up in the analasys afterwards. post tide analasys always take current ftp (100% …

But the second number does not match the targeted powers for the intervals. The targets for this workout were 239, 243, 248, 252 & 256. I know the numbers are close in the example I show above, but they aren’t always for some of my workouts. Sometimes the variance is even bigger. And for clarity, I…

Ah - that’s helpful re: the green line. Thanks!!

yes, its close. maybe ftp setting is different in the app on mobile vs computer"?

Could be this 1 second bug: [image] Bug: Average Power different in workout and interval graphics TrainerRoad Software Just as an example look at the “VO2 Max 3” interval from the workout below. The workout overview shows different values than shown in the interval sectio…

The one I note above was Gawler (should be called Gawdawful :wink: But on intervals in Rattlesnake - for example - that second number is sometimes off target by 10 watts

Interval Power Analytics on TR

TrainerRoad Software

Rizzi February 2, 2020, 12:38am 10

Could be this 1 second bug:

Topic		Replies	Views
Bug: Average Power different in workout and interval graphics TrainerRoad Software bug	6	1121	February 3, 2021
Online analyzer tool question TrainerRoad Software	7	998	May 6, 2020
Target Power in Workout Analysis lower than in Workout TrainerRoad Software	3	477	January 26, 2021
Inconsistent interval "target value" TrainerRoad Software	10	918	January 11, 2021
Target power doesn't match in workout summary TrainerRoad Software	6	581	April 26, 2020

Interval Power Analytics on TR

Related topics