And this for the roller bolts:
- At this point, it’s a good idea to test if the problem has been corrected. If the issue persists, continue by tightening the two 3mm roller bolts as follows:
Tools needed:
-
Heat Gun or Blow Dryer
-
3mm Allen wrench in like-new condition
-
Grease
-
Heat the roller bolt by aiming the heat gun or blow dryer directly at one specific bolt hole in the roller for roughly 2 minutes (5 minutes or longer if using blow dryer, dependent upon wattage).
-
Remove the bolt using a 3mm Allen wrench. If removal proves difficult, stop and apply more heat. Adding more heat is always preferable to stripping the bolts.
-
Clean any remaining thread lock residue off the bolt with a dry rag or paper towel.
-
Lightly grease the bolt , being careful to avoid greasing the tip of the bolt that contacts the axle.
-
Re-install the greased bolt , tightening to 6nm (ideal).
-
Repeat this process with the other bolt. If clicking noise persists, increase torque to the bolts. If the issue still remains, please reach back out to us for warranty or replacement.
