Having had the Rally XC100 pedals for a few months here are some thoughts:
- Some concerns about whether or not they were calibrating correctly but after reading some of this thread and acquiring a torque wrench to properly tighten them they seem to be consistent with my other power sources (Kickr & Vector 3)
- I have used them for gravel and MTB and mostly have avoided pedal strikes but have definitely had a few. So far they are holding up well with that.
- So far no dropout issues that frequently arose with my Vector 3 pedals (until the 2nd battery cover replacement which seems to have permanently fixed that)
- Be careful adjusting the tension. If you loosen them too much a key part will fall out and if you don’t lose it getting it back in is a huge headache.